GepRC Taker H743 Mini 32Bit 60A Stack

GEPRC TAKER H743 MINI 32Bit 60A Stack

The GEPRC TAKER H743 MINI 32Bit 60A Stack combines the powerful TAKER H743 MINI Flight Controller with the TAKER H60 MINI 60A 4-in-1 ESC in a compact 20×20 mm form factor.

The Flight Controller features an STM32H743 processor paired with an ICM42688-P gyroscope. An integrated LC filter and support for an external gyro clock help ensure clean and reliable signal processing. 16 MB of Blackbox storage is available for recording and analysing flight data.

For convenient installation and setup, the FC features Bluetooth for wireless Betaflight tuning, an integrated barometer, 7 freely assignable UARTs, and a dedicated connector for DJI Air Units. With a total of 8 motor outputs, the controller is also suitable for X8 configurations.

The TAKER H60 MINI ESC runs on open-source AM32 firmware and delivers up to 60A continuous current per channel, with a 65A burst rating for 5 seconds. Its wide 3S to 8S LiPo voltage range makes the stack suitable for a variety of FPV builds. An integrated TVS protection circuit also helps protect the power system against voltage spikes.

Features GEPRC TAKER H60 MINI 60A 4-in-1 ESC

• 60A 4-in-1 ESC with AM32 firmware
• 3-8S LiPo support
• 20×20 mm mounting pattern
• 8 motor outputs for X8 builds
• TVS voltage spike protection
• DShot150 / DShot300 / DShot600

Features GEPRC TAKER H743 MINIFlight Controller

• STM32H743 H7 Flight Controller
• ICM42688-P gyroscope
• 20×20 mm mounting pattern
• Bluetooth for wireless FC setup
• 16 MB Blackbox storage
• Integrated barometer
• 7 UARTs
• Plug-and-play connector for DJI Air Unit
• USB-C connector
• Betaflight OSD with AT7456E
• Dual 5V / 12V BEC
• Integrated LC filter

Shipping Contents

• 1 × GEPRC TAKER H743 MINI Flight Controller
• 1 × GEPRC TAKER H60 MINI 32Bit 60A ESC
• 1 × 50V 1000µF capacitor
• 1 × DJI Air Unit cable, SH1.0-6P
• 1 × FC connection cable, SH1.0-8P
• 1 × FC-to-GPS/RX cable, SH1.0-4P
• 1 × XT60 cable, 12AWG / 55 mm
• 10 × M3 silicone dampers
• 5 × M3×22 stack screws
• 6 × M3 nylon lock nuts
• 5 × M3 hex nuts